User's Manual

Installer Menu
HLX-24 Hardware Installation and Programming Manual 29
3. When the signal is detected you are asked to press Enter to store and
save your selection.
4. Once the selection is stored, you can then choose to configure each of the
remote control buttons (except the * button that serves as a status
announcement) to behave in one of the following options:
 Restore Default (sets the button to its original functionality)
 Operate PGM 1
 Status Request
5. At any time press ESC to exit the menu.
Once you exit the menu (after saving the enrollment) you cannot change the
button’s behavior, unless you delete the remote and re-enroll it.
To delete a remote control or proximity card:
1. Select the pre-enrolled remote control number 01 to 08 by either
browsing the list of remotes using Menu or by entering the remote
number using the numeric keypad.
You are asked to confirm deletion.
2. Press Enter to delete or ESC to go back.
6.3.3 RF Siren
You can enroll up to four RF sirens. You can choose to remove enrolled sirens.
To enroll/remove an RF siren:
1. Select the required Siren location, #01–04 by either browsing the keys
using Menu or by entering the siren’s number using the numeric keypad.
2. Enroll the RF Siren when the
WAITING FOR SIGNAL option is displayed by
activating the siren’s tamper.
3. When the signal is detected, you are asked to press Enter to store and
save your selection
If the selected location has a siren enrolled, you are asked whether you
wish to delete it.
4. Press Enter to delete or ESC to go back.
6.3.4 Keypads
You can enroll up to four keypads. You can choose to remove enrolled
keypads.
To enroll/remove a keypad:
1. Select the required keypad location, #01–04 by either browsing the keys
using Menu or by entering the keypad’s number using the numeric
keypad.
2. Enroll the keypad when the
WAITING FOR SIGNAL option is displayed.
3. When a signal is detected, you are asked to press Enter to store and save
your selection