User's Manual

Installer Menu
HLX-24 Hardware Installation and Programming Manual 27
• Crossing zones can be of zones with the same type.
• One cross zone gets the mutual zone automatically. Ex zone 1 cross zone 2
then zone 2 automatically cross zone is 1.
 Cross Time: Select the time period between two zones defined in
cross mode for alarm event. If one linked zone is opened and the
other linked zone is not opened, a zone cross error is sent to the
monitoring station. The default is 30 seconds.
 Abort Window: A period of time after a sensor initiates an alarm
condition that allows the user additional time to disarm the system
before an alarm is transmitted. Select Enabled to allow the zone to
abort an alarm event during the Alarm Abort Window defined in the
system. The default setting is Enabled.
6.3 Enrolling
Change Code
Zones
ENROLLING
Security
Communications
Automation
Messages
Maintenance
Detectors
Remote Controls
Sirens
Keypads
Repeaters
The third submenu is ENROLLING.
Browse the desired devices listed below to be enrolled using Menu and access
it by pressing Enter:
 Detectors
 Remote controls
 Sirens
 Keypads
 Repeaters