User Manual

VIP Menu
HomeLogiX, HLX-40 User Guide
Page 21
6. VIP Menu
6.1 General
VIP (Voice Interface Programming) features include Voice
Assist, where the panel uses voice to prompt the user. Either the
system or a remote private telephone can initiate a VIP session.
• VIP Session Initiated by a Remote Telephone User: The
remote telephone user can initiate a VIP session by calling
the system’s number. The system answers after a preset
number of rings, press * to initiate connection the system
broadcasts the site description and waits for a code. The
remote user must enter a valid master code to start a
session.
• VIP Session Initiated by the System: The system initiates a
session (if enabled by the installer) upon an event
occurrence. The system calls the private number and asks
that you press * to initiate the connection after which the
system broadcasts the site and the event description. The
user must then enter a valid master code to enter the VIP
menu. The system hangs up after approximately 60
seconds of no activity. In the event that there is no answer
from a private phone or disconnected by the user by
pressing 9, the system switches to the next private number.
The system retries calling the programmed private phones
for a preprogrammed number of attempts unless the user
disconnects the call session by pressing 9 in which case the
session is stopped completely.
The system switches to voice menu mode when a valid master
code is entered. During voice menu mode, the system uses
voice messages for menu options. Follow the voice instructions.
Press 0 at any time to jump one level up in the menus.
The following options are available:
• Press 1 to enter the arming options submenu
• Press 2 to enter the automation options submenu
• Press 3 to enter the voice operation options submenu
• Press 4 to receive a status report
• Press 9 to exit the menu and disconnect the system.