Technical Specs

Table Of Contents

6.2. R estore to Factory Defaults

To restore the reader to default settings, before power-on, connect the orange wire (green LED control) and yellow

wire (Buzzer Control) to GND for two or more seconds. The red LED will turn ON for 2 seconds, followed by a long

two second beep. This indicates successful Multi-Smart™ Readers power up with default settings.

6.3. Standby Mode

In standby mode, two LED bars will be in steady RED condition.

EM 125 KHz And CSN 13.56 MHz Credential Read

When a 125 kHz credential or a 13.56 MHz credential is detected by the reader, both LED bars will flash GREEN for

250ms, and the reader will sound short beep for 300ms. This indicates a successful card read and transfer on the

Wiegand port. Then, the reader will return to standby mode and the right light bar stays solid RED.

Multi-Smart™ Readers Installation & User Guide