User's Manual

AYC-Qx4 family manual Page 35
Note:
• The AYC- F/G/M60 must be in Normal Mode to enter the
Programming mode.
• The factory four-digit Programming Code is 1234.
• If a Programming Code is not entered within five seconds,
the AYC- F/G/M60 will return to Normal mode.
Exiting Programming Mode
1) Press the “#” key two times within 2 seconds
• You will hear 3 beeps.
• The Door LED will turn off
and the Mode LED will r
2) Wrong entries may re
eturn to Normal.
set the controller back to Normal mode.
ming mode and return to Normal
hanging Lock Strike Code
used as a method to quickly test
ller, the default Lock
mode.
2) ress “1” to enter Menu 1.
) r the new code you wish to set
3) While in Programming
mode, if no key is pressed
for one minute the AYC-
F/G/M60 will exit Program
mode.
C
The Lock Strike Code is mainly
the Lock Strike Relay during installation.
When the first user is added to the contro
Strike Code will automatically be deleted. Once the code is
programmed again, it will not be deleted with the entry of
additional User Codes.
1) Enter Programming
P
1
• The Mode LED will turn
red.
3 Ente
as the Lock Strike Code.
? ? ? ?
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Program
Green
Mode/Transmit
Door/Program
Red
Green