User's Manual

Installation
AY-Z12 Installation Manual Page 8
To Install the Reader:
1. Determine an approximate location for the installation of the
Reader.
2. Peel off the back of the self-adhesive installation label
template and locate it at the required location.
3. Using the template as a guide, drill the holes (the size of
which are indicated in the template) to install the Reader or
spacer onto the surface.
4. Drill a 7/16” (10mm) hole for the cable. In the event that you
are installing the reader on metal, place a grommet or
electrical tape around the edge of the hole and use the MP-
Z02 spacer.
5. Route the interface cable from the Reader to the Controller.
A linear type power supply is recommended.