Installation guide

Page 35 of 40 September 2005 Synergy 2 SD Ordering Guide, v16A
• All inputs are SMPTE-259M-C serial digital non-looping.
• The Synergy 2 comes standard with 16 inputs and additional inputs are purchased in sets
of 8.
• Inputs can be used for either key or video.
• The reference input is SMPTE-259M-C and is chosen as one of the standard inputs.
External A-D conversion is required for analog references.
Video Outputs
Number of Outputs:
MLE 1 PGM 1 each
MLE 1 PV 1 each
MLE 2 PGM (main PGM) 2
MLE 2 PV 1
Main PV without overlay 1
Main PV with overlay (option) 1
Clean feed 1
Expansion (future use) 4
Aux Bus (1 to 12) 1 per bus
Output Characteristics:
Return loss > 18 dB @ 270 MHz
Rise time 800 ps +/- 10%
Signal level 800 mV +/- 10%
DC offset 0 volts
Rise and fall time 1 ns (20 – 80%)
Overshoot < 8%
• All video outputs are 10-bit SMPTE-259M-C serial digital.
• EDH is inserted into all video outputs except untimed Aux Buses and can be disabled.
System Timing
• All video inputs zero time relative to reference input, auto timing will correct for inputs
out of time by up to +/- 0.25 line (16us).
• The delay through the switcher is less than one-quarter line (approx. 12us). This delay
can be manually increased in 37ns steps to a maximum of 32us in order to accommodate
late video signals.
Note: Specifications are subject to change without notice.