User manual

MUX-6258-A Series User Manual (Iss. 04) Card-edge Menus • 5–5
Menu Descriptions
This section briefly summarizes the menu parameters available in the card-edge display of the
card.
0 — Home
This read-only menu displays the product name and the slot the card is installed in the frame.
1 — Factory Defaults
This function enables you to return all controls to their factory default values.
To reset the card parameters to factory default values using the card-edge controls:
1. Rotate SW1 to 1. The Four Character Display displays “Fact Def”.
2. Toggle SW2 down and hold for 3 seconds.
3. Release SW2.
2 — Reference Source
This menu enables you to select where the card will look for a reference. The choices are Frame
Reference 1 (Fr 1), Frame Reference 2 (Fr 2), and Video (Vid). Refer to the section “Reference
Compatibility” on page 3-5 for a list of supported reference formats.
3 — Loss of Input
Use this menu to select what type of video displays at the system’s outputs when the input video
signal is lost or invalid.
4 — Test Pattern
This menu enables you to specify the type of test pattern to output. Note that this setting is not
retained on power down.
5 — Group Select
This menu enables you to select the embedded group before enabling the group, assigning
sources to the channels, and backup sources. This menu is used in conjunction with Menus 6 to E.
6 — Group Enable
Use this menu to determine if the selected group is embedded in the output or not.