User manual

4–4 • DashBoard Menus MUX-6258-A Series User Manual (Iss. 04)
Product Tab
Table 4.2 summarizes the read-only information displayed in the Product tab.
Hardware Tab
Table 4.3 summarizes the read-only information displayed in the Hardware tab.
Table 4.2 Product Tab Items
Tab Title Item Parameters Description
Product
Product
MUX-6258-A or
MUX-6258-A-xx
Supplier Ross Video Ltd.
Board Rev ## Indicates the board version
Rear Module # Indicates the rear module installed
Board S/N ###### Indicates the board serial number
Software Rev ##.## Indicates the software version
Firmware Rev #.### Indicates the firmware version
Table 4.3 Hardware Tab Items
Tab Title Item Parameters Description
Hardware
HW Status
OK
Indicates the status of the hardware
including the SFP module. Some
messages displayed are dependent on the
settings in the Alarms Enable tab.
FPGA load invalid
Incomp I/O module
Current out of spec
Internal Error
SFP Temp Low
SFP Temp High
SFP Power High
SFP Power Low
SFP Tx Fault
SFP Not Detected
Voltage (mV) # Supply Voltage
Current (mA) # Current consumption of card
Optical Module
Temperature (C)
#
Indicates the temperature of the Optical
Module
Optical Tx
Wavelength (nm)
#
Indicates the wavelength being
transmitted
CPU Headroom # Processing power available
RAM Available #/## On-board processing memory available
Uptime (h) #
Displays the number of hours since the
last reboot of the card
Configuration Bank # Storage count