Operator`s manual

8–4 • Specifications CrossOver 6 / 12 User Manual (v4.0)
All Stop — 3 F2 D0* *Data byte is unused
Read Lamp Status — 3 78 0
Write Lamp Status
— 3 F8 — Included for GVG100
spec completeness only.
Write Button Press Both 3 FB <button>
Send Mem To Editor — 3 7E Not yet implemented
Load Mem From Editor — 73 FE Not yet implemented
**
Data byte 1:
Bit 7: 0=select elements, 1=select elements
and perform transition
Bit 4-6: 4=select key 1, 5=select key 2,
6=select bkgd
Bit 0-3: binary coded decimal (valid range is
b0-b1001, or 0-9)
Data byte 2:
Bit 6-7: Ignored Bit 4-5: 4=select key 3, 5=select key 4
Bit 0-3: binary coded decimal (valid range is
b0-b1001, or 0-9)
Data byte 3:
Bit 4-7: Ignored
Bit 0-3: binary coded decimal (valid range is
b0-b1001, or 0-9)
Table 8.4 GVG100 Supported Analog Controls
Name MLE/Keyer Byte Code Notes
Key Clip Keyer 0x0A
Key Gain Keyer 0x0B
Vert. Position MLE 0x11
Horz. Position MLE 0x12
Key Matte Fill Hue MLE 0x14 Key mattes not supported
Pattern Size MLE 0x15
Chroma Key Hue Keyer 0x17 Write not supported
Key Matte Border Hue Keyer 0x18 Key mattes not supported
Key Matte Border Sat Keyer 0x19 Key mattes not supported
Key Matte Border Lum Keyer 0x1A Key mattes not supported
Key Matte Fill Lum Keyer 0x1B Key mattes not supported
Aspect MLE 0x1C Aux MLEs not supported
Border Softness MLE 0x1D Aux MLEs not supported
Border Width MLE 0x1E Aux MLEs not supported
Key Matte Fill Sat Keyer 0x1F Key Mattes not supported
Rotate X — 0x20 Not supported
Rotate Y — 0x21 Not supported
Rotate Z — 0x22 Not supported
3D Position X — 0x23 Not supported
Table 8.3 GVG100 Supported Commands
Name MLE/Keyer Length Byte Code Data/Notes