Operator`s manual

CrossOver 6 / 12 User Manual (v4.0) Memories, USB Storage, and Upgrades • 5–7
For More Information on...
• performing software upgrades, refer to the section
“Software Upgrades” on page 5-8.
• FTP access to the USB drive, refer to the section
“Creating an FTP Connection” on page 4-6.
Saving Switcher Settings
You can save up to 10 sets of memory registers,
personality settings, and installation settings on a
USB drive.
To save to a USB drive:
1. Insert a USB drive into the USB port.
2. Press MENU.
3. Press the SAVE Wipe Pattern button.
4. Use the left knob to select the set you wish to
save to.
5. Select the register you want to save as follows:
• All — Press the All knob to save all
registers to the selected set.
• Memories — Press the Mems knob to
save memory registers to the selected set.
• Custom Controls — Press the Cust
knob to save custom control registers to the
selected set.
•Press NEXT.
• Personality — Press the Pers knob to
save personality settings to the selected set.
• Installation — Press the Inst knob to
save installation settings to the selected set.
6. Press the Confrm knob to perform the save.
Press the Cancel knob to cancel the save.
Note:
• Turn the middle knob when browsing sets to
display the full text of long set names
• Saving items overwrites the same items in the
selected set (e.g. saving memory registers
overwrites previously saved memory registers in
the selected set but does not affect personality or
installation settings previously saved to the same
set).
• The * symbol next to an item indicates that there is
a previously saved version of that item in the
selected set.
For More Information on...
• accessing the USB port, refer to the section
“Frame Overview” on page 1-3.
Loading Switcher Settings
You can load switcher settings that were previously
saved to a USB drive.

Memory registers that were empty when saved will
erase the contents of the same memory register on
your switcher when loaded from a USB drive.
To load from a USB drive:
1. Insert a USB drive containing memory register,
personality, and installation sets into the USB
port.
2. Press MENU.
3. Press the LOAD Wipe Pattern button.
4. Use the left knob to select the set you wish to
load from.
5. Select the register you want to load as follows:
• All — Press the All knob to load all
registers from the selected set.
• Memories — Press the Mems knob to
load memory registers from the selected set.
• Custom Controls — Press the Cust
knob to load custom control registers from the
selected set.
• Press NEXT.
• Personality — Press the Pers knob to
load personality settings from the selected set.
• Installation — Press the Inst knob to
load installation settings from the selected set.
6. Press the Confrm knob to perform the save.
Press the Cancel knob to cancel the save.
Note:
• Turn the middle knob when browsing sets to
display the full text of long set names
• The * symbol next to an item indicates that there is
a previously saved version of that item in the
selected set.
For More Information on...
• accessing the USB port, refer to the section
“Frame Overview” on page 1-3.
MENU
NEXT
MENU
NEXT