Operator`s manual

CrossOver 6 / 12 User Manual (v4.0) Advanced Operation • 4–13
8. Press the Device knob to save your
selection.
9. Press the Confrm knob to commit the
change. Press the Cancel knob to discard
the change and return to the previous setting.
Cameras
You can control the orientation, lens effects, and shot
storage and recall of an external camera.

You may experience unresponsive camera controls
for a short period of time immediately after loading
switcher settings from a USB drive, rebooting, or
performing a switcher software upgrade.
To control camera orientation:
1. Select the input source that has been associated
with your camera.
2. Use the Pan knob to pan the camera left and
right.
3. Use the Tilt knob to tilt the camera up and
down
4. Use the Zoom knob to zoom the camera
lens in and out.
Note:
• You can also use the positioner on the CrossOver
12 to control camera pan and tilt. This works from
any camera control menu
To control camera focus and iris:
1. Select the input source that has been associated
with your camera.
2. Press NEXT until Focus is displayed.
3. Press the Focus knob to toggle between
auto and manual focus modes.
4. When in manual focus mode, use the Focus
knob to focus the camera.
5. Press the Iris knob to toggle between auto
and manual iris modes.
6. When in manual iris mode, use the Iris knob
to control the lens iris size.
To store a shot:
1. Select the input source that has been associated
with your camera.
2. Set the camera orientation, focus, and iris
settings as required.
3. Press NEXT until Store is displayed.
4. Use the Store knob to select a shot number
to store.
5. Press the Store knob to store the shot.
Note:
• The shot number defaults to the last recalled shot.
To recall a shot:
1. Select the input source that has been assigned to
your camera.
2. Set the camera orientation, focus, and iris
settings as required.
3. Press NEXT until Recall is displayed.
4. Use the Recall knob to select a shot number
to recall.
5. Press the Recall knob to recall the shot.
Note:
• You can not recall a second shot while a shot is
being recalled. Wait for the first recall to finish
before attempting to recall another shot.
• The shot number defaults to the last recalled shot.
• When you store a memory register, the last
recalled shot is stored in the memory register and
is recalled when the memory register is recalled.
For More Information on...
• storing and recalling memory registers, refer to the
section “Memory System Overview” on page 5-1.
Inverting Camera Axes
You can selectively invert the camera pan and tilt
axes on a per-input basis.
To invert camera axes:
1. Press MENU.
2. Press the CONFIG Wipe Pattern button.
3. Press the Input knob to display the Input
menu.
4. Use the Input knob to select the input that
the camera is assigned to.
5. Press NEXT until Device is displayed.
6. Press the Device knob to display the
Device menu.
NEXT
NEXT
NEXT
MENU
NEXT