Operator`s manual

4–12 • Advanced Operation CrossOver 6 / 12 User Manual (v4.0)
controlled. You can also edit device settings and
remove a device from the switcher.
To add a device:
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press NEXT until Device Config is
displayed.
4. Press the Device Config knob to display
the Device Configuration menu.
5. Press the Add knob to display the Device
Add menu.
6. Use the Slot knob to select a slot to assign
the device to.
7. Use the Type knob to select the device type
you are adding.
8. Use the other knobs to set device settings as
necessary.
9. Press any knob to save your changes.
10. Press the Confrm knob to commit the
change. Press the Cancel knob to discard
the change and return to the previous setting.
Note:
• The device you are adding may require additional
setup parameters. Refer to the Ross Video External
Device Setup Sheet for your particular device for
complete connection and configuration
information.
To edit a device:
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press NEXT until Device Config is
displayed.
4. Press the Device Config knob to display
the Device Configuration menu.
5. Use the Add knob to select the device to
edit.
6. Press the Edit knob to display the Device
Edit menu.
7. Use the knobs to edit the device settings as
necessary.
8. Press any knob to save your changes.
9. Press the Confrm knob to commit the
change. Press the Cancel knob to discard
the change and return to the previous setting.
Note:
• The device you are editing may require additional
setup parameters. Refer to the Ross Video External
Device Setup Sheet for your particular device for
complete connection and configuration
information.
To remove a device:
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press NEXT until Device Config is
displayed.
4. Press the Device Config knob to display
the Device Configuration menu.
5. Use the Add knob to select the device to
remove.
6. Press the Delete knob to remove the device.
7. Press the Confrm knob to commit the
change. Press the Cancel knob to discard
the change and return to the previous setting.
To assign a device to an input:
1. Press MENU.
2. Press the CONFIG Wipe Pattern button.
3. Press the Input knob to display the Input
menu.
4. Press NEXT until Device is displayed.
5. Use the Input knob to select the input you
wish to assign the device to.
6. Press the Device knob to display the Device
menu.
7. Use the Device knob to select the device to
assign to the selected input.
MENU
NEXT
MENU
NEXT
MENU
NEXT
MENU
NEXT