Operator`s manual

4–2 • Advanced Operation CrossOver 6 / 12 User Manual (v4.0)
3. Use the corresponding knob to change the
following:
•Pattern (Pattrn) — To find and select a
desired pattern.
• X Pos or Y Pos — To position the wipe
pattern.
• Aspect — To adjust the aspect ratio.
• Border Size (Border) — To adjust the size of
the border.
• Image Softness (Soft) — To blur or harden
the border.
• Border color (only available if you set the
Border Size greater than 0.0%)
›Use the Load knob to select a preset color.
Press the Load knob to load the color.
›Use the BHue, BSat, and BLum knobs
until the desired color is achieved.
• Rotation (Rot) — To rotate the pattern.
• Horizontal (HMult) and Vertical (VMult)
Multiplication — To create multiple instances
of the pattern.
Note:
• You can select a pattern using the Pattern Buttons.
This also displays the Wipe menu.
• The X Pos and Y Pos can be adjusted using the
positioner (CrossOver 12 only).
• Aspect adjustments are not available for all
patterns.
• Circle, left square, right square, and diagonal
patterns with aspect adjustments can not be
rotated.
Modifying DVE Transitions
DVE transitions can be modified to suit the needs
and style of your production. The following effects
can be adjusted:
•Time
• Direction
• DVE Effect
To modify time and direction:
1. Press DVE to display the DVE menu.
2. Press NEXT until Time is displayed.
3. Use the Time knob to change the duration of
the DVE transition.
4. Use the Dirctn knob to set the direction of
the DVE transition. You can choose from the
following:
• Fwd — Transition runs in the forward
(default) direction.
• Rev — Transition runs in the reverse
direction.
5. Press the Dirctn knob to alternately enable
and disable the flip-flop direction feature. You
can choose from the following:
• Enabled (FF) — The first time a DVE
transition is performed, it runs in the forward
direction. Performing a second DVE
transition runs in the reverse direction.
• Disabled — DVE transitions always run in
the direction specified in step 4 above.
To select a DVE effect for a transition:
1. Press DVE to display the DVE menu.
2. Press NEXT until Effect is displayed.
3. Use the Effect knob to select which DVE
effect to use for the transition.
Note:
• You can also select an effect by pressing the Wipe
Pattern buttons as shown in Table 4.1:
•Using the Effect knob allows you to select
additional DVE effects that are not assigned to
pattern buttons.
DVE
NEXT
Table 4.1 DVE Effect Selection
Pattern
Button
Single Press Pattern
Button DVE Effect
Double Press Pattern
Button DVE Effect
0 Push Left Push Right
1 Push Up Push Down
2 Squeeze Horizontal Push Up-Right
3 Squeeze Vertical Push Down-Left
4 Push Up-Left Push Down-Right
5 Squeeze Up-Right Squeeze Down-Left
6 Squeeze Up-Left Squeeze Down-Right
7 Squeeze to Center Fly Through
8 Circle Left Circle Right
9 Stretch Tumble
DVE
NEXT