Operator`s manual

3–12 • Basic Operation CrossOver 6 / 12 User Manual (v4.0)
Note:
• Mattes may also be selected on the Aux bus. Use
the MATTE button on the desired Aux bus to
select a matte color for that bus.
For More Information on...
• accessing an Aux bus, refer to the section “Aux
Buses” on page 4-5.
To change the pattern:
1. Press and hold SHIFT.
2. Press BLACK/MATTE to display the
Matte menu.
3. Press NEXT until WASH is displayed.
4. If the WASH knob is Off, toggle it On by
pressing the WASH knob.
5. Use the Pattern buttons to select the desired
pattern.
Note:
• If the wash is turned off, the pattern does not
display.
• Pattern washes are not available on Aux buses.
Using other Wash Adjustments
Washes can be adjusted by using these modifiers:
• Size — Size
• X-Pos, Y-Pos — Position
• Aspect — Aspect Ratio
• Border — Border Appearance
• Softness — Edge Softness
• Hue 2, Sat 2, and Lum 2 — Secondary Color
The Aspect function allows you to alter the shape of
the selected wash pattern. For example, if you want
the wash to be oval shaped, select the circular pattern
and adjust the aspect ratio until the desired oval is
created.
Borders are effects created around the selected
pattern for the wash. The Border function allows
you to adjust the appearance of the border.
The Softness function controls the wash edge
appearance. It is a pattern edge effect produced by
mixing key source and key fill signals allowing
variable control of edge softening.
The Hue 2, Sat 2, and Lum 2 functions control the
secondary color. If you are creating a wash and want
to add a second color, adjusting these options will
generate and modify another color set within the
pattern.
To apply other adjustments:
1. Press and hold SHIFT.
2. Press BLACK/MATTE to display the
Matte menu.
3. Press NEXT until the desired modifier is
displayed.
4. Adjust the desired modifier by rotating the
corresponding knob.
Note:
• If the wash is turned off, the pattern does not
display.
• The wash pattern and the key pattern mask are
shared. Any adjustments affect both patterns.
Fade to Black
Fade to Black is achieved by selecting the black
source and performing a transition.
To fade to black:
1. Press BKGD and all on-air key buttons
simultaneously to include them in the transition.
2. Select a transition type.
3. Press BLACK/MATTE on the Preset bus.
4. Fade to black by sliding the Fader, pressing
CUT, or pressing AUTO TRANS.
MATTE
SHIFT
MATTE
NEXT
SHIFT
MATTE
NEXT
BKGD
BLACK
CUT
AUTO
TRANS