Operator`s manual

CrossOver 6 / 12 User Manual (v4.0) Configuration • 2–13
Note:
• If you are using Format Conversion or Frame
Sync (FCFS) channels, transitions are locked to
F1.
For More Information on...
• FCFS channels, refer to the section “Format
Conversion and Frame Sync” on page 2-1.
Editor Control
Your switcher can be controlled by external editors
using the GVG100 protocol. It can also generate
EDL (Edit Decision List) files for use in non-linear
editing suites.
To configure external editor control:
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press NEXT until Editor is displayed.
4. Use the Editor knob to enable or disable
external editor control.
Note:
• You can view the LTC timecode from the second
page of the Status menu.
• Refer to the Ross Video External Device Setup
Sheet for your editor for cabling and configuration
information.
• You can quickly turn editor control on or off by
pressing and holding the MENU button, and
press PERS.
For More Information on...
• external editor control, refer to the section “Editor
Port” on page 4-17.
• installation and configuration of the TSC-9902
LTC to Serial Converter, refer to your TSC-9902
documentation.
• Live EDL, refer to the section “Live Edit Decision
Lists (EDL)” on page 4-7.
Transition Area Behavior
You can set the behavior of the transition area to suit
your needs.
To configure the Next Transition Area behavior:
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press NEXT until Trans Area is displayed.
4. Press the Trans Area knob to display the
Transition Area menu.
5. Use the Trans knob to set the behavior of
the Next Transition area after a transition is
performed. You can choose from the following:
• Reset — The Next Transition area is reset to
a background dissolve transition
• NotRst — The Next Transition area is not
reset.
6. Use the Auto 2 knob to set the behavior
when a a transition is paused by pressing AUTO
TRANS during a transition. You can choose
from the following:
• HltFwd — The transition pauses. When you
resume the transition, it completes as
originally set.
• HltRev — The transition pauses. When you
resume the transition, the transition proceeds
in reverse and the switcher returns to the
on-air state it was in before the transition was
started.
• Rev — The transition immediately reverses
and the switcher returns to the on-air state it
was in before the transition was started.
7. Use the ARKey knob to set whether a Key
remains or is removed from the Next Transition
area after a dedicated key transition is
performed. You can choose from the following:
• Off — The Key is removed from the Next
Transition area after a dedicated key
transition is performed.
• On — The Key remains active in the Next
Transition area after a dedicated key
transition is performed.
8. Use the RlClip knob to set whether GPI
outputs assigned to input sources are triggered
before a transition. You can choose from the
following:
• Force — GPI outputs assigned to input
sources going on-air in a transition are always
triggered.
• User — You can choose whether GPI outputs
assigned to input sources going on-air in a
transition are triggered.
NEXT button Secondary Function
You can configure a secondary function of the
NEXT button allowing it to be used, in conjunction
with the Wipe Pattern buttons, to trigger GPI outputs.
MENU
NEXT
MENU
MENU
NEXT
NEXT