Operator`s manual

2–10 • Configuration CrossOver 6 / 12 User Manual (v4.0)
5. Use the SAT knob to adjust the Panel Glow
saturation.
6. Use the LUM knob to adjust the Panel Glow
luminance.
Note:
• It is not recommended to set the Panel Glow color
to red. Red indicates a source is on-air.
For More Information on...
• hue, saturation, and luminance, refer to the section
“Selecting Colors” on page 1-6.
Saving Color Schemes
You can save a custom Panel Glow color scheme so
that it may be recalled as needed.
To save a custom Panel Glow color scheme:
1. Modify the Panel Glow to obtain the desired
appearance.
2. Press MENU.
3. Press the USER Wipe Pattern button.
4. Press the Scheme knob to display the
Color Scheme menu.
5. Press NEXT until Save is displayed.
6. Use the Save knob to select the custom
scheme you wish to save.
7. Press the Save knob to save the color
scheme.
8. Press the Confrm knob to commit the save
(if there was a color scheme saved to the
selected custom scheme, it is overwritten). Press
the Cancel knob to cancel the save.
Loading Color Schemes
You can load a custom color scheme or one of the
preset color schemes that are included on your
switcher.
To load a custom Panel Glow color scheme:
1. Press MENU.
2. Press the USER Wipe Pattern button.
3. Press the Scheme knob to display the
Color Scheme menu.
4. Press NEXT until Load is displayed.
5. Use the Load knob to select the color
scheme you want to load. You can select from a
list of presets or one of the custom color
schemes you have previously saved.
6. Press the Load knob to load the color
scheme.
7. Press the Confrm knob to commit the load.
Press the Cancel knob to cancel the load.
Power-Save Mode
The switcher goes into a Power-Save mode after a
user-defined amount of time (20 minutes by default)
without user interaction. Touching any control will
wake the switcher. Any functionality associated with
the touched control is ignored until the unit is active
and all lights and display are turned on.
During Power-Save mode, video related hardware is
not affected and video signals are still passed through
the switcher.
To configure the power-save timeout:
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press the right knob to set the switcher
power-save behavior. You can choose from the
following:
• PwrSve — All buttons and the menu display
turn off. The switcher conserves as much
power as possible without affecting on-air
video.
• Sleep — The menu display turns off.
Buttons light and slowly fade in a raindrop
pattern.
4. Use the right knob to set the power-save
timeout (in minutes). You can select a value
from 0 (off) to 999 minutes.
Transition Rate Units
You can select the units used to specify durations for
various video transitions. Choose the units that you
are most comfortable working with.
To select the units for switcher transitions:
1. Press MENU.
2. Press the PERS Wipe Pattern button.
MENU
NEXT
MENU
NEXT
MENU
MENU