Operator`s manual
2–8 • Configuration CrossOver 6 / 12 User Manual (v4.0)
6. Use the In/Out knob to select a source to
display in the box You can choose from the
following:
• PGM — Program bus output
• PV — Preset bus output
• 1-12 (1-6 for CrossOver 6) — Source inputs
• M1-4 — Media-Store channels
Note:
• Media-Store channels 3 and 4 are only available
when the Media-Store mode is set to Dual,
Swish, or Swish+.
• Inputs assigned to boxes 3-10 are displayed with a
red border when they are on-air. A green border is
displayed when the input is selected on the Preset
bus.
• Boxes 1 and 2 do not have colored borders.
For More Information on...
• setting the Media-Store mode, refer to the section
“Media-Store Modes” on page 6-1.
CrossOver CleanSwitch
CrossOver CleanSwitch allows you to perform
high-quality transitions between video signals with
embedded audio streams. All 16 embedded audio
channels are passed through the switcher.
The setup consists of your switcher, an openGear
DFR-8300 series frame, and an MDK-111A-Lite.
Refer to your CrossOver CleanSwitch
documentation for details on cabling and transition
behavior.
To configure your switcher for External Audio
mode:
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press NEXT until Ext Audio is displayed.
4. Press the Ext Audio knob to display the
External Audio menu.
5. Use the ExtAud knob to enable or disable
external audio switching.
6. Use the Type knob to select the type of
audio transition that is performed. You can
choose from the following:
• V-Fade — Audio from the source going
off-air is faded to no volume and then the
audio from the source going on-air is faded to
full volume.
• X-Fade — Audio from the source going
on-air is simultaneously faded up to full
volume while the audio from the source going
off-air is faded to no volume.
7. Press NEXT until IPAddr is displayed.
8. Use the Field knob to select the various
fields in the IP address.
9. Use the Value knob to modify the field
values and enter the IP address of your
MDK-111A-Lite card.
10. Press the IPAddr knob to save the IP
address.
11. Press the Confrm knob to commit the
change and exit the menu. Press the Cancel
knob to return to the External Audio menu for
further editing.
Note:
• Using Frame Sync strips embedded audio data.
Ensure that Frame Sync is turned off for any input
or bus you are using with external audio mode.
Refer to the section “Format Conversion and
Frame Sync” on page 2-1 for details.
IP Address
The switcher is equipped with an Ethernet port to
allow remote access. By default, the switcher uses
DHCP to automatically obtain an IP address. You
can manually set an IP address, network mask, and
default gateway if your network does not have a
DHCP server.
Note:
• You do not need to connect your switcher to a
network for it to function.
To configure a DHCP IP address for your
switcher:
1. Ensure your switcher is connected to your
network via the ethernet port.
2. Press MENU.
3. Press the SYSTEM Wipe Pattern button.
4. Press NEXT until IP Addr is displayed.
5. Press the IP Addr knob to display the IP
Address menu.
MENU
NEXT
NEXT
MENU
NEXT