Operator`s manual

CrossOver 6 / 12 User Manual (v4.0) Configuration • 2–7
3. Use the CLEAN knob to select where in the
output stream the Clean Feed is derived. You can
choose from the following:
• Key 1 — Clean Feed output is taken before
any keys are added.
• Key 2 — Clean Feed output is taken after
Key 1 but before Key 2 or 3 is added.
• Key 3 — (CrossOver 12 only) Clean Feed
output is taken after Key 1 and 2 but before
Key 3 is added.
Note:
• There is no physical Clean Feed output. The Clean
Feed signal is available from any Aux bus.
• Recalling a memory register using Memory AI
may cause the Clean Feed output to look different
than expected. Memory AI allows key elements to
be recalled to other keys than originally resulting
in different key layering.
For More Information on...
• Accessing the Clean Feed output on an Aux bus,
refer to the section “Selecting a Special Source on
an Aux Bus” on page 4-6.
• Memory AI, refer to the section “Recalling
Memory Registers” on page 5-4.
• resource sharing, refer to the section “Resource
Sharing” on page 2-11.
MultiViewer
The MultiViewer™ allows you to view ten video
sources from a single output BNC. Any video source
on the switcher, including Program, Preview, and
Media-Store channels, can be assigned to any box on
the MultiViewer.
Figure 2.5 MultiViewer Layout
To enable or disable MultiViewer:
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press the MultiView knob to display the
MultiViewer menu.
4. Use the Output knob to select an output to
configure for MultiViewer layout display.
• Pgm2 — Configure the Program 2 output.
• Prview — Configure the Preview output.
5. Use the MView knob to enable or disable
MultiViewer display on the selected output.
• On — The MultiViewer layout is displayed
on the selected output.
• Off — The MultiViewer layout is not
displayed on the selected output.
6. Use the Transp knob to set the transparency
of the MultiViewer source labels.
7. Press NEXT > NEXT.
8. Use the AncSrc knob to select the ancillary
data that is included in the MultiViewer output.
• PV — Select this option to include the
ancillary data from Preview with the
MultiViewer output.
• PGM — Select this option to include the
ancillary data from Program with the
MultiViewer output.
Note:
• The MultiViewer layout is configured
independently for each output.
• The outputs can be configured to display the
MultiViewer layout simultaneously.
• If you turn on the MultiView for Pgm2, Aux 4 is
turned off and the MultiView output is fed out of
that output BNC instead.
For More Information on...
• ancillary data, refer to the section “Ancillary
Data” on page 2-5.
To assign sources to the MultiViewer display:
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press the MultiView knob to display the
MultiViewer menu.
4. Press NEXT.
5. Use the Box knob to select a box on the
MultiViewer display. Refer to Figure 2.5 for the
locations of the boxes.
1
2
3 4 5
6
7 8 9
10
MENU
NEXT
NEXT
MENU
NEXT