Operator`s manual

ManualsBrandsRoss ManualsComputer equipmentCrossOver 6

CrossOver 6 / 12 User Manual (v4.0) Introduction • 1–5

If you wish to return to the first page of a top-level

menu, Press and hold the NEXT button and then

press the STORE button.

Note:

• You can exit the menu system by pressing any

button other than a Wipe Pattern or source button

while the menu system is active.

Knobs

The control panel has three continuously rotatable

pushbutton knobs located below the display screen.

The knobs are used to select and alter menu options.

To use the knobs:

• Rotate the knob to adjust the corresponding value.

To default a value using the knobs:

• Double-press a knob to default the value currently

associated with that knob.

Buttons

The buttons illuminate to indicate one of four states:

• Glow — When a button on the board is lit with the

Panel Glow color, it is in a resting state. All

buttons are lit with the Panel Glow color unless

selected, turned on, in use, or on-air.

• On-air — Source buttons corresponding to on-air

sources are red.

• Menu — A button is green when the associated

menu is displayed.

• On/Selected — Several buttons are On/Off

buttons. If the button feature is turned off, it is lit

with the Panel Glow color. If the button feature is

turned on, the button is lit with a brighter shade of

the Panel Glow color.

For More Information on...

• adjusting the panel glow, refer to the section

“Customizing the Panel Glow” on page 2-9.

Button Inserts

Insert films can be installed into most switcher

buttons. Insert films allow you to label specific

source buttons, control buttons, or replace the default

button names with those of a different language.

Installing Your Own Insert Films

All inserts must be cut to the dimensions indicated

for small (1) or large (2) buttons.



Using insert films that do not meet the recommended

criteria may damage the button cap and diffuser.

Figure 1.9 Insert Sizing

To install switcher button inserts:

1. Remove the Cap Assembly (1) from the Switch

Assembly (2) by grasping it firmly and pulling

away from the control panel surface.

2. Remove the Lens (1) from the Diffuser (2) using

a common end micro screwdriver.

3. Place the Insert Film (2) into the Lens (1) so the

readable side is facing up. The notches on the

sides of the Lens must be at the sides of the text

on the Insert Film.

0.504"

0.444"

0.528"

0.468"