Product manual

Switcher Sets
The switcher stores configuration and operation data in
a number of registers that contain the individual entries
for items such as memories or personality settings. These
registers can be stored as a single archive file, or as a
register set that contains all the individual register of that
type; all memories for example. These files are stored
into Setups on USB drive. Different Setups can be created
for different shows or applications, allowing you to
quickly locate and recall the switcher configurations.
The switcher stores information in the following registers:
• Memory — contains all the memories for all MLEs
• Custom Control — contains all the custom control
banks and macros
• Personality — contains all the user interface
settings, such as transition rates, that are stored
under the PERS menu
• Installation — contains all the external device
setup, and software settings for the switcher
To Store a Set
Switcher Sets can only be stored to a USB drive. The
USB drive must be present before you try to store the
settings. A total of 10 Sets of switcher setup information
can be stored onto the same USB drive.
1.
Insert a USB drive into the USB Port on the
switcher. You must wait 5 seconds for the
switcher to recognise the USB drive.
2.
Press MENU > SAVE.
3.
Use the Save knob to select the set (0-9) you
want to store the switcher registers to.
4.
Press the knob to select the registers you want
to store to the selected set. If an (*) is shown on
the menu, that register already exist in the set
and will be overwritten.
•
ALL — store all registers to the set
•
Mems — store only the memory registers
to the set
•
Cust — store only the custom control
registers to the set
•
Pers — store only the personality registers
to the set
•
Inst — store only the installation registers
to the set
5.
Press Confrm.
To Load a Set
Switcher Sets can only be loaded from a USB drive. The
USB drive must be present before you try to load the
settings.
1.
Insert your USB drive into the USB Port on the
switcher. You must wait 5 seconds for the
switcher to recognise the USB drive.
2.
Press MENU > LOAD.
3.
Use the Load knob to select the set (0-9) you
want to load the switcher registers from.
4.
Press the selected set. Only registers with an (*)
shown on the menu exist in the set.
•
ALL — recall all registers from the set
•
Mems — recall only the memory registers
from the set
•
Cust — recall only the custom control
registers from the set
•
Pers — recall only the personality registers
from the set
•
Inst — recall only the installation registers
from the set
5.
Press Confrm.
38 • Switcher Sets — Carbonite Operation Manual (v6.1)