Product manual
14.
Adjust the Transition area as follows:
The Transition area is the range of pixels that
are left over (i.e. not in the Shadow or
Translucency area). The Transition settings
allows you to adjust the appearance of the
Transition area.
a)
Use the Type knob to select Trans.
b)
Use the Cntrl knob to select Gain.
c)
Use the Value knob to adjust the appearance
of the Transition colors.
• Increasing the Gain value makes the
Transition area pixels more opaque.
• Decreasing the Gain value makes the
Transition area pixels more transparent.
15.
Adjust the Translucency area as follows:
The Translucency settings allow you to adjust
the appearance of clear items such as eye-glass
lenses.
a)
Use the Type knob to select Trnslc
b)
Use the Cntrl knob to select Gain
c)
Use the Value knob to adjust the appearance
of the Translucent colors
• Increasing the Gain value causes the
translucent colors to appear more
opaque.
• Decreasing the Gain value causes the
translucent colors to appear more
transparent.
a)
Use the Cntrl knob to select Range.
b)
Use the Value knob to adjust the range of
the Translucent colors.
• Increasing the Range value widens the
Translucent area by including more
hues from the Background range (the
lower-end of the range is defined by
the Shadow range you just set).
• Decreasing the Range value narrows
the Translucent area by excluding hues.
16.
Press NEXT.
17.
Use the Mask knob to apply a mask to the key.
DVE Keys
The DVE Key allows you to apply digital video effects,
such as scale, crop, aspect ratio, position, and border to
video image.
To Set Up a DVE Key
A DVE key requires DVE resources that may not be
available. Depending on how your switcher is configured,
you may be asked to steal the resources from another
element, or be prevented from using the resources.
1.
Select the keyer that you want to set up a DVE
Key on.
2.
Select the video signal on the key bus that you
want to use for the key.
3.
Press DVE for the key type.
4.
Use the X Pos knob to position the DVE key
horizontally. You can also use the positioner.
5.
Use the Y Pos knob to position the DVE key
vertically. You can also use the positioner.
6.
Use the Size knob to adjust the overall size of
the DVE key vertically. You can also twist the
positioner.
7.
Press NEXT.
8.
Use the Aspect knob to adjust the aspect ratio
of the DVE key.
9.
Use the Border knob to apply a border to the
DVE key. Refer to the section To Apply a Border
to a DVE Key on page 30 for information on
borders.
10.
Press NEXT. If a border is applied to the DVE
key, you must press NEXT multiple times to get
to the next step.
11.
Crop the DVE key horizontally as follows:
a)
Use the HCrop knob to crop the DVE key
horizontally on both the left and right sides
at the same time.
b)
Press HCrop and use the Left/R knob to
crop the DVE key horizontally on the left
side only.
c)
Press Left/R and use the L/Rgt knob to crop
the DVE key horizontally on the right side
only.
12.
Crop the DVE key vertically as follows:
a)
Use the VCrop knob to crop the DVE key
vertically on both the top and bottom sides
at the same time.
b)
Press VCrop and use the Top/B knob to
crop the DVE key vertically on the top side
only.
Carbonite Operation Manual (v6.1) — Keying • 29