Product manual

Document Information
• Ross Part Number: 4802DR-110-06.1
• Release Date: May, 2012. Printed in Canada
The information contained in this document is subject
to change without notice or obligation.
Copyright
©
2012 Ross Video Limited. All rights reserved.
Contents of this publication may not be reproduced in
any form without the written permission of Ross Video
Limited. Reproduction or reverse engineering of
copyrighted software is prohibited.
Patents
This product is protected by the following US Patents:
4,205,346; 5,115,314; 5,280,346; 5,561,404; 7,034,886;
7,508,455; 7,602,446; 7,834,886; 7,914,332. This product
is protected by the following Canadian Patents: 2039277;
1237518; 1127289. Other patents pending.
Notice
The material in this document is furnished for
informational use only. It is subject to change without
notice and should not be construed as commitment by
Ross Video Limited. Ross Video Limited assumes no
responsibility or liability for errors or inaccuracies that
may appear in this document.
Trademarks
•
is a trademark of Ross Video Limited.
• Ross, ROSS, ROSS
®
, MLE, Vision, Octane,
Carbonite, CrossOver, CrossOver Solo, CrossOver
Studio, Squeeze & Tease, Squeeze & Tease
WARP, OverDrive, RossGear, openGear,
DashBoard Control System, SoftMetal, XPression,
Furio, and CamBot are registered and unregistered
trademarks of Ross Video Limited.
• Windows is a registered trademark of Microsoft
Corporation in the United States and other
countries.
• All other product names and any registered and
unregistered trademarks mentioned in this
document are used for identification purposes only
and remain the exclusive property of their
respective owners.
Important Regulatory and Safety
Notices to Service Personnel
Before using this product and any associated equipment,
refer to the “Important Safety Instructions” listed in
the front of your Setup Manual to avoid personnel injury
and to prevent product damage.
Product may require specific equipment, and/or
installation procedures to be carried out to satisfy certain
regulatory compliance requirements. Notices have been
included in this publication to call attention to these
specific requirements.
Symbol Meanings
Protective Earth: This symbol identifies a
Protective Earth (PE) terminal, which is provided
for connection of the supply system's protective
earth (green or green/yellow) conductor.
Important: This symbol on the equipment refers
you to important operating and maintenance
(servicing) instructions within the Product Manual
Documentation. Failure to heed this information
may present a major risk of damage or injury to
persons or equipment.
Warning: The symbol with the word “Warning”
within the equipment manual indicates a
potentially hazardous situation which, if not
avoided, could result in death or serious injury.
Caution: The symbol with the word “Caution”
within the equipment manual indicates a
potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
It may also be used to alert against unsafe
practices.
Warning Hazardous Voltages: This symbol is
intended to alert the user to the presence of
uninsulated “dangerous voltage” within the
product enclosure that may be of sufficient
magnitude to constitute a risk of shock to
persons.
ESD Susceptibility: This symbol is used to
alert the user that an electrical or electronic
device or assembly is susceptible to damage
from an ESD event.
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
2 • Document Information — Carbonite Operation Manual (v6.1)