User manual

4–4 • Menus ADC-8733A User Manual (Iss. 02B)
Signal Status
When the Signal Status indicator in DashBoard is green, the following conditions are present:
• A valid input timing signal is present and selected.
• A valid reference signal is present when a reference is required and that reference
standard matches the input standard. The Line Sync or Frame Sync modes require that a
reference signal be present.
When the Signal Status indicator in DashBoard is red, one of the following errors have occurred:
• A valid input timing signal is not present or selected.
• A valid reference signal is not present or selected.
• The reference does not match the input standard.
Setup Menus
Table 4.2 summarizes the Setup Menu options available in DashBoard for the ADC-8733A.
Signal
(Read-only)
Signal Status
Green
Indicates that the card is functioning
normally and no anomalies are detected.
Refer to the section “Signal Status”
Red
The reference does not match the input
standard or an error has occurred. Refer to
the section “Signal Status”
Input Status
Signal Present
Indicates the presence of an input signal
No Signal
Reference
b
Reference OK
Indicates the presence of a reference
signal
No Reference
Line Standard
525
Indicates that the input signal is 525-line
standard
625
Indicates that the input signal is 625-line
standard
a. This message displays when the following rear modules are installed when using the AAM-8581: 8310AR-030, 8310AR-031,
8320AR-030, 8320AR-031, 8320AR-040, and 8320AR-041.
b. The ADC-8733A only accepts BLS Reference signals.
Table 4.2 Setup Menu Items
Tab Title Item Parameters Description
Setup
Input Standard
RGB SMPTE
Specifies the standard of the input signal
RGB MII
a
RGB NTSC
a
YUV SMPTE
YUV MII
a
YUV BETA
Table 4.1 Status Tab Items
Tab Title Item Parameters Description