User manual

ADC-8733A User Manual (Iss. 02B) Installation • 2–5
Cabling for the ADC-8733A
This section provides information for connecting cables to the installed Rear Modules on the
DFR-8300 series frames. Connect the input and output cables according to the following sections.
DFR-8310 Series Frame Cabling Overview
In the DFR-8310 series frames, the ADC-8733A is used with the following Rear Modules:
• R1-8733 Rear Module — Each card occupies one slot and provides four SD-SDI outputs,
one tracking pulse output, and a reference input. Cable your ADC-8733A according to
Figure 2.2.
• R1C-8733 Rear Module — Each card occupies one slot and provides four audio inputs,
two SDI outputs, one tracking pulse output, and a reference input. Cable your
ADC-8733A-C or ADC-8733A-SC according to Figure 2.3.
DFR-8321 Series Frame Cabling Overview
In the DFR-8321 series frames, the ADC-8733A is used with the following Rear Modules:
• R2-8733 Full Rear Module — Each card occupies two slots and provides four SD-SDI
outputs. Cable your ADC-8733A according to Figure 2.2.
• R2C-8733 Full Rear Module — Each card occupies two slots and provides four audio
inputs, two SDI outputs, one tracking pulse output, and a reference input. Cable your
ADC-8733A-C or ADC-8733A-SC according to Figure 2.3.
• R2S-8733 Split Rear Module — Each card occupies one slot and provides two SD-SDI
outputs. Note that each rear module provides connections for two cards. Cable your
ADC-8733A according to Figure 2.4.
Figure 2.2 Cable Connections for the R1-8733
and R2-8733 Rear Modules
Figure 2.3 Cable Connections for the R1C-8733
and R2C-8733 Rear Modules