User manual

3–2 • User Controls ADC-8434-A User Manual (Iss. 01)
Card Overview
This section provides a general overview of the ADC-8434-A components.
Figure 3.1 ADC-8434-A — Components
SW1 — Remote Control
Use SW1 to disable remote control of the ADC-8434-A from DashBoard.
Set SW1 as follows:
• ON — Select this setting to disable remote control from DashBoard. The parameters and
settings cannot be changed via DashBoard and must be changed using the card-edge
controls. You can still monitor the status of the card using DashBoard.
• OFF — Select this setting to control the ADC-8434-A exclusively from DashBoard. The
card-edge controls are ignored.
SW2 — DIP Switch Control
Use SW2 to determine whether DIP Switch settings are applied or ignored.
Set SW2 as follows:
• ON — DIP Switch status is reported in DashBoard, and DIP Switch settings are applied.
Any parameter adjustments made in DashBoard are ignored.
• OFF — DIP Switch status is reported in DashBoard, however DIP Switch settings are
ignored. Parameter adjustments made in DashBoard are applied.
SW3
SW3 is used for factory service only. Do not use SW3 unless instructed to do so by Ross
Technical Support personnel.
SW4
SW4 is used for factory service only. Do not use SW4 unless instructed to do so by Ross
Technical Support personnel.
SW5, SW6 — Output Mode Selection 1
SW5 and SW6 are used in conjunction to set the output mode of the first audio converter. Refer
to the section “Setting the Output Modes” on page 3-4 for details.