User manual

ADC-8434-A User Manual (Iss. 01) Installation • 2–5
Cabling for the ADC-8434-A
This section provides information for connecting cables to the installed Rear Modules on the
DFR-8300 series frames. Connect the input and output cables according to the following sections.
DFR-8310 Series Frame Cabling Overview
In the DFR-8310 series frames, the ADC-8434-A is used with the following Rear Modules:
• 8310AR-036 Rear Module — Each module occupies one slot and accommodates one
card. This rear module provides four 75ohm AES/EBU outputs, and one stereo analog
audio input. (Figure 2.2)
DFR-8321 Series Frame Cabling Overview
In the DFR-8321 series frames, the ADC-8434-A is used with the following Rear Modules:
• 8320AR-036 Full Rear Module — Each module occupies two slots and accommodates
one card. This rear module provides four 75ohm AES/EBU outputs, and one stereo
analog audio input. (Figure 2.2)
Figure 2.2 Cable Connections for the 8310AR-036 and 8320AR-036 Rear Modules