User manual

Bank C-8: Freeze Mode
The input image can be frozen (ADC-8032B-S only) if any of the following conditions occur:
• The user selects Manual Freeze (Forced Freeze, Bank C, position 9)
• There is a loss of input signal (Input Loss Mode, Bank C, position A)
• A hotswitch occurs (Hotswitch Mode, Bank C, position B)
The Freeze Mode function allows you to set what will be output when a freeze occurs: the last Field 1,
the last Field 2, or the last Full Frame. Use the following steps to set the freeze mode:
2. Select Bank C, and rotate Function Select to position 8.
3. Select the desired mode according to the table below:
• Toggle Mode Select up to advance up the list.
• Toggle Mode Select down to descend down the list.
Bank Function Select Mode Select Heads-Up Display Label Default
C 8
+ Frame
Field 2
- Field 1
FRZ MODE FRAME
FLD 2
FLD 1
FLD 1
Bank C-9: Forced Freeze
The output can be manually frozen (ADC-8032B-S only) using the Forced Freeze mode. When
enabled, the freeze will use either field 1, field 2 or the entire frame (as determined by the Freeze
Mode function).
Use the following steps to enable or disable the Forced Freeze mode:
1. Select Bank C, and rotate Function Select to position 9.
2. Select the desired mode:
• Toggle Mode Select up to freeze the image. The FREEZE LED is on.
• Toggle Mode Select down to un-freeze the image, and allow input video to
pass through. The FREEZE LED is off.
Bank Function Select Mode Select Heads-Up Display Label Default
C 9
+ Freeze
- Pass Through
FREEZE FORCE
PASS
PASS
ADC-8032B User Manual (Iss. 02B) Using Banks • 4-21