User manual

Bank A-8: Video Gain
Use the following steps to adjust the ADC-8032B’s output video gain:
1. Select Bank A, and rotate Function Select to position 8.
2. Adjust video gain up or down as required:
• Toggle Mode Select up to increase video gain.
• Hold Mode Select up to increase video gain continuously.
• Toggle Mode Select down to decrease video gain.
• Hold Mode Select down to decrease video gain continuously.
Bank Function Select Mode Select Heads-Up Display Label Default
A 8
+ Increase
- Decrease
VID GAIN (###.#)% 100%
Note
Video Gain is one of the six “Proc Amp” controls that can be
reset using Factory Defaults (Bank A, position E).
Bank A-9: Black Level Offset
This setting is a black level offset that is not affected by the NTSC Setup function (Bank B, position
1). For example, with Black Level Offset at 1 IRE, a setup level of 7.5 IRE, and NTSC Setup off, the
black level will be 8.5 IRE. With NTSC Setup on and a setup level of 7.5 IRE, the black level will be
1.0 IRE. Use the following steps to change the card’s output black level.
1. Select Bank A, and rotate Function Select to position 9.
2. Choose the desired Black Level Offset setting:
• Toggle Mode Select up to increase the black level offset.
• Hold Mode Select up to increase the black level offset continuously.
• Toggle Mode Select down to decrease the black level offset.
• Hold Mode Select down to decrease the black level offset continuously.
Bank Function Select Mode Select Heads-Up Display Label Default
A 9
+ Increase
- Decrease
BLK OFF (##.#) IRE 0 IRE
Note
Black Level Offset is one of the six “Proc Amp” controls that
can be reset using Factory Defaults (Bank A, position E).
4-8 • Using Banks ADC-8032B User Manual (Iss. 02B)