User manual

Reference Termination
The reference signal can be terminated on the card. See Figure 3. Use JP6 to set reference termination
options:
• To terminate the reference on this card install the jumper in the TERM position (the
lower two pins).
• To leave the reference un-terminated install the jumper in the UNTERM position
(the upper two pins).
Common
O/P 8
TERM
Common
FRAME
UNTERM
TERM
Common
UNTERM
Common
O/P 8
FRAME
TerminationReference
Figure 3. Jumper 6 Reference and Termination Option Pin Locations
SMPTE Fault Reporting
(Optional) Using Figure 2 and the card silk-screening, set Jumper JP5 (269M Fault Reporting) to
enable or disable the card’s SMPTE alarm:
• Set jumper to EN to enable SMPTE fault reporting (default setting)
• Set jumper to DIS to disable SMPTE fault reporting
(See Chapter 5, “SMPTE 269M Fault Reporting” for details on fault reporting.)
Board Installation
Use the following steps to install the ADC-8032B in a RossGear 8000 series digital distribution frame:
1. Refer to the User Manual of the RossGear 8000 series frame, to ensure that the
frame is properly installed according to instructions. If this module is to be installed
in any compatible frame other than a Ross Video product, refer to the frame
manufacturer’s manual for specific instructions.
2. Please note that heat and power distribution requirements within a frame may dictate
specific slot placement of cards. Cards with many heat-producing components
should be arranged to avoid areas of excess heat build-up, particularly in frames
using convectional cooling.
3. After selecting the desired frame installation slot, hold the ADC-8032B card by the
edges and carefully align the card edges with the slots in the frame. Then fully insert
the card into the frame until the rear connection plug is properly seated.
BNC Labels
Affix the supplied BNC label, as per the included instructions, to the BNC area on the rear of the rack
frame.
ADC-8032B User Manual (Iss. 02B) Installation and Setup • 2-3