User manual

Jumper Locations

JP6

External

Reference

and

Terminatio

JP5

Fault

Reporting

Input

Figure 2. Jumper Locations

Use the following sections to set up ADC-8032B jumpers. These setups are performed before

installing the unit in the frame, but may be repeated as required. Refer to Figure 2 for card jumper

locations.

Video Input

Using the figure above and the card silk-screening, set J3 (Input Select) to select the input video

standard:

• Auto — automatically select between

NTSC / PAL-B / PAL-M / PAL-N (default setting)

• NTSC — forces NTSC decoding

• PAL-B — forces PAL-B decoding

• PAL-M — forces PAL-M decoding

• PAL-N — forces PAL-N decoding

Reference Selection

An analog composite reference is required for Line Sync and Frame Sync modes. The reference can

come from BNC 7 or 8 (BNC 7 and 8 are passively connected on the card) or from the Frame. See

Figure 3. Use JP6 to set reference options:

• To select the frame as the reference source, install the jumper in the FRAME

position (the upper two pins)

Note

When the frame is the reference source, the termination jumper

must be set to UNTERM position.

• To select BNC 7 or 8 as the reference source, install the jumper in the O/P8 position

(the lower two pins)

2-2 • Installation and Setup ADC-8032B User Manual (Iss. 02B)