User's Manual

netAqua

USER MANUAL Roslen Eco-Networking Products

When the value ON is programmed for the Abort field, the previously entered Watering Cycle or Zone will

stop watering.

The Time value will be accepted and changeable only if a Zone number is programmed.

3.10.3. Programming Conflicts

If programmed watering cycles interfere in any way, the watering cycle with the lower number will have

precedence. For example, if watering cycle 1 is scheduled to start before the completion of watering

cycle 3, then watering cycle 3 will abort at the moment when watering cycle 1 starts. If watering cycle 4 is

scheduled to start before the completion of watering cycle 2, then watering cycle 2 will complete, and

watering cycle 4 will begin at the point in its sequence when watering cycle 2 ends.

Manual cycle starts have precedence over any programmed watering cycles. For example, if watering

cycle 3 is currently executing and a manual start is programmed for watering cycle 1, then watering cycle

3 will be automatically aborted and the manually started cycle 1 will start. Likewise, manual zone starts

have precedence over any programmed watering cycles. For example, if a manual start is programmed

for a single zone, then any ongoing watering cycle will be aborted automatically.

3.11. Factory Default Configuration

The default settings are:

• User ID: Admin

• Password: Password

• DHCP: enabled

• IP Address: 192.168.1.44 cable, 192.168.1.45 WiFi

• Net Mask: 255.255.255.0

• Gateway Address: 192.168.1.1

• WiFi interface (if provided): disabled

• WiFi interface settings: cleared

• Zone solenoid valve control outlets (relays): Off

• Global watering: disabled

• Watering timer control: disabled

• Watering timer programming: cleared

• Network Time Protocol: enabled

• LCD and backlight: disabled for continuous operation (120s timeout)

• Monitoring: disabled.

3.11.1. Reset to Factory Default

A return to default configuration settings will occur when the ENTER button is held for more than 30 and

less than 60 seconds. The reset with return to the default configuration will initiate after the ENTER

button is released in the qualifying window.

An alternative method to restore the default configuration is provided in the Browser Interface, in the

System Settings tab.