User's Manual

netAqua

USER MANUAL Roslen Eco-Networking Products

• Zone 2 duration

• Zone 3 duration

• Zone 4 duration

• Zone 5 duration

• Zone 6 duration

• Zone 7 duration

• Zone 8 duration

• Zone 9 duration (unless Zone 9 has been configured for Master Valve control).

3.10.1.1. Watering Cycle Enable

Possible values for the Watering Cycle enable are:

a. Enabled: the cycle starts watering at the programmed Start Time.

b. Disabled: the cycle will not water.

3.10.1.2. Watering Cycle Start Time

Possible values for the Watering Cycle Start Time are:

a. Hour: Possible values for the Hour field are 1 through 24, or 1 AM through 12 AM and 1 PM

through 12 PM, depending on the time format setting in the Browser Interface.

b. Minute: Possible values for the Minute field are 0 through 59.

c. Half of day: Possible values are AM or PM, if enabled in the Browser Interface. If Browser

Interface is set for 24 hour time, then neither AM nor PM is displayed.

3.10.1.3. Watering Frequency

Possible values for Watering Frequency are:

a. Daily: the Watering Cycle operates every day.

b. Every Second Day: the Watering Cycle operates every second day. When this selection is

made, the Watering Cycle will first operate not later than 24 hours from the moment that the

selection was made.

c. Every Third Day: the Watering Cycle operates every third day. When this selection is made, the

Watering Cycle will first operate not later than 24 hours from the moment that the selection was

made.

d. Odd Days: the Watering Cycle will operate on every odd day of the month.

e. Even Days: the Watering Cycle will operate on every even day of the month.

f. Press ENTER to Set Days of Week: this value is selected to choose individual days of operation.

3.10.1.3.1. Set Days of Week

For each day of the week, the possible values are:

a. Enabled: the Watering Cycle will operate on the selected day.

b. Disabled: the Watering Cycle will not operate on the selected day.

3.10.1.4. Zone Duration

Possible values for Zone Duration are OFF, 1, through 120 minutes.

3.10.2. Programmable Fields for Manual Watering Operation Control

The programmable fields for the Manual Watering Operation Control page are:

• Cycle: 1, 2, 3, or 4

• Zone: 1, 2, 3, 4, 5, 6, 7, 8, or 9 (unless Zone 9 is configured for Master Valve control)

• Time: OFF or minutes, 1 through 120

• Abort: YES or NO.