User's Manual

netAqua

USER MANUAL Roslen Eco-Networking Products

When the programming level for a watering cycle is reached, the first programmable field is highlighted.

Press the SCROLL UP or SCROLL DOWN buttons to select the field to edit. Press the PROG button to

edit the selected variable.

The current selected programmable field is highlighted and blinking. Press the SCROLL UP or SCROLL

DOWN buttons to change the selected programmable field. Press the ENTER button to accept the

change.

At any point while in the programming mode, when a programming field is not flashing, hold the ENTER

button for two seconds to accept the programmed values and exit the programming mode.

The possible values for each programmable field are specified later in Section Error! Reference source

not found.. A special case exists when you wish to program the watering cycle frequency. One of the

possible values is “Select Days” or after it is programmed it will show the days previously programmed

like “MoWeFr”. When you choose this value, and it is highlighted and flashing, you press the PROG

switch again and a page to select the days of the week is presented. When the program days of the

week page is reached, the first programmable field is highlighted. Just like on other programming pages,

press the SCROLL UP or SCROLL DOWN buttons to select the field to edit and press the PROG button

to edit the selected variable. As before, the current selected programmable field is highlighted and

blinking. Press the SCROLL UP or SCROLL DOWN buttons to change the selected programmable field.

Press the ENTER button to stop editing the selected value, and hold the ENTER button for two seconds

to accept the change. Hold the SCROLL UP button for at least two seconds, to return the LCD interface

to the Watering Cycle page that is in the programming mode.

The general arrangement of a watering frequency program page data follows the concept shown in

Figure 40.

Mon: enable Tue: enable

Sun: enable

Hold ENTER when done

Wed: enable Thu: enable

Fri: enable Sat: enable

Figure 40: Watering Cycle Days of the Week Programming

3.9.4.2. Watering Cycles Help in Status Mode

The ? character blinks in the upper right corner of each Watering Cycle page while these are in Status

mode, that is programming mode has not been entered. When you hold both the SCROLL UP and

SCROLL DOWN buttons together for two seconds, the help page shown in Figure 41 is displayed.

Cycles Help: p1 of 1

- Hold SCROLL UP to exit

- Hold PROG to edit page

- Press SCROLL DOWN

for next page

Figure 41: Watering Cycle Status Mode Help Page

Holding SCROLL UP returns the interface to the Watering Cycle page in Status mode.

3.9.4.3. Watering Cycles Help in Programming Mode

The ? character blinks in the upper right corner of each Watering Cycle page while these are in

Programming mode. When you hold both the SCROLL UP and SCROLL DOWN buttons together for two

seconds, the help pages shown in Figure 42 are displayed.