Manualshelf

User's Manual

ManualsBrandsRoslen Eco-Networking Products ManualsHome AutomationnetAQUA Wi-Fi Web Enabled Irrigation Controller
41424344454647484950
netAqua
TM
USER MANUAL Roslen Eco-Networking Products
v1.0.03 © 2014 by Roslen Eco-Networking Products. All rights reserved Page 48 of 59
Manual Watering
Operation
Hold PROGRAM to run
Figure 38: Manual Watering Operation Page
3.9.4. Watering Cycles LCD Pages
As mentioned, the user can descend to Watering Cycles level from the top level Automatic Watering
Settings page by holding SCROLL DOWN. The Watering Cycles level contains four LCD pages where
the user can view the four watering cycle settings and can enter the programming mode to change these
by holding the PROG pushbutton switch.
There are four Watering Cycle pages, one for each of the four available cycles. Each Watering Cycle
page contains the following data:
• Cycle: Enabled or Disabled Start time: HH:MM ?
• Frequency: Daily, or M Tu W Th F Sa Su, or Every Odd Day, or Every Even Day, or Every
Second Day, or Every Third Day
• Zone 1 watering time: minutes or OFF
• Zone 2 watering time: minutes or OFF
• Zone 3 watering time: minutes or OFF
• Zone 4 watering time: minutes or OFF
• Zone 5 watering time: minutes or OFF
• Zone 6 watering time: minutes or OFF
• Zone 7 watering time: minutes or OFF
• Zone 8 watering time: minutes or OFF
• Zone 9 watering time: minutes or OFF (unless Zone 9 has been configured for Master Valve
control).
The time is displayed in either AM/PM or 24-hour designations, depending on the time format setting in
the Browser Interface.
The ? character in the upper right corner of the display indicates that a help page is available for the
Watering Cycle page. Hold the SCROLL UP and SCROLL DOWN buttons together for two seconds to
descend to the help page.
The general arrangement of a Watering Cycle page data follows the concept shown in Figure 39.
Cycle 1: Enabled 12:00PM ?
Z4:OFF Z5:OFF Z6:OFF
Z7:OFF Z8:OFF
Frequency: Daily
Z1:OFF Z2:OFF Z3:OFF
Figure 39: Watering Cycle
The Watering Cycle pages for all four watering cycles follows the same format.
3.9.4.1. Watering Cycles Programming
When the PROG pushbutton switch is held for two seconds, the interface descends to the automatic
watering programming level of hierarchy.