User's Manual
netAqua
TM
USER MANUAL Roslen Eco-Networking Products
v1.0.03 © 2014 by Roslen Eco-Networking Products. All rights reserved Page 42 of 59
synchronized between the Browser Interface settings and at device settings configured via the
LCD/pushbutton switches.
The order of precedence for temperature, rainfall, and humidity controls is:
1. Local rain
2. Internet rain
3. Local temperature
4. Internet temperature
5. Internet humidity
Either local or internet thresholds can trigger watering modifications. For example, if the local rain sensor
is not active but internet weather indicates rain, watering will not occur.
Humidity threshold, if enabled, decreases automated watering if no temperature thresholds are crossed.
If either temperature threshold is crossed, the humidity threshold is disregarded.
3.8.1.2.2. Watering Cycles
The controls provided for each watering cycle include:
7. Enable watering cycle: Yes, No
8. Watering timer:
a. Frequency: Daily, Select Days, Even Days, Odd Days, Every Two Days, Every Three
Days
b. Start time: hour, minute
c. Duration for each of the nine zones: minutes (OFF, 1 to 120 minutes)
3.8.1.2.3. Manual Operation
The controls provided for manual starts include:
1. Cycle number (1 through 4)
2. Zone number (1 through 9 (or 8 if Master Valve is enabled))
3. Duration for specified zone: minutes (0 to 120).
When a manual start is initiated, it executes immediately. Only one manual start is possible concurrently.
Manual start vs. timer control conflicts are discussed in Section 3.10.3.
3.8.1.2.3.1. Abort
A control is provided to abort watering. When this is selected during an active watering cycle, the cycle
aborts. When this is selected during an active manual start, the manual start aborts.
3.8.1.3. System Settings Page
The System Settings inputs are divided into sections, with each section including:
1. Network settings:
a. Ethernet port:
i. Static or DHCP IP address assignment
ii. IP address (used for Static address)
iii. Network mask of the connected network
iv. Gateway IP address (must be provided when Static address is used).
v. MAC address, provided for reference and not editable.
b. WiFi port: