User's Manual

netAqua
TM
USER MANUAL Roslen Eco-Networking Products
v1.0.03 © 2014 by Roslen Eco-Networking Products. All rights reserved Page 33 of 59
Figure 31: Manual IP Address Settings
Once these settings are made, you’re ready. Simply open a browser on your computer and in the
address bar type in the netAQUA IP address, 192.168.1.46, and the Status page of the Browser Interface
will open. From then on, you can make any changes that you need to any of the settings available on the
Browser Interface.
When you’re done, you’ll need to return the computer to the settings needed for it to work on your
network. Typically, all that you’ll need to do is to change the IP address configuration to select the
“Obtain an IP address automatically” radio button. Then you can close all of the Control Panel related
windows and that should be it. In some cases, you might wish to restart your computer for it to properly
rest the network settings.
2.8. Update the Software in the netAQUA
It is always best to keep the software in your netAQUA updated to the most recent version available.
Please check the roslen.com website for any available software updates. The current software version
running on your netAQUA is shown at the bottom of the Status tab, or on the Software tab. The current
bootloader version is also shown on the Software tab. The bootloader is the base software that loads the
main program on start-up.