User's Manual

netAqua
TM
USER MANUAL Roslen Eco-Networking Products
v1.0.03 © 2014 by Roslen Eco-Networking Products. All rights reserved Page 17 of 59
Figure 11: Network Settings in Browser Interface
To enable the WiFi interface, check the Enabled box. Next, type-in the name of your WiFi network in the
SSID space, select the type of security used on your WiFi network (most often it will be WPA/WPA2), and
type-in the password in the Security key space
You should probably leave the default selection of DHCP for IP Address Assignment. This will make your
router assign the network address to the netAQUA. You can change it to Static, but then you must
update the IP Address Parameters to match your network. You also need to take care that you select a
Static address that will be unique on your network. If your selected address is the same as that for some
other device, your network will not work properly and access to the netAQUA Browser Interface may be
compromised. Also, it is important that if you use a Static address, you also provide your local network
address of the router, which you can type-in the Gateway space. The MAC address shown in this section
is the MAC address of the WiFi module. The MAC address is the physical address for the WiFi interface
of your netAQUA, and is not changeable.