User's Manual

netAqua
TM
USER MANUAL Roslen Eco-Networking Products
v1.0.03 © 2014 by Roslen Eco-Networking Products. All rights reserved Page 12 of 59
Figure 3: Webbed Grommet for Cable Entry
The other end of the Ethernet cable should be inserted into one of the ports marked LAN or Ethernet on
your router, or network switch.
Next, power-up the netAQUA. You can watch the start-up progress on the LCD. Alternatively, the Status
LED, which is the one closer to the front of the device, will flash progressively faster as the start-up
proceeds. Once the device is fully up and running, the netAQUA Main Control page will be displayed on
the LCD, and the Status LED will be on green.
Note that the LEDs and the four control pushbuttons at the bottom of the netAQUA are labeled on the
shield that is inside the device, in the location above the buttons.
Figure 4: Ethernet LAN Ports on Back of Router