Quick Start Guide

ManualsBrandsRoslen Eco-Networking Products ManualsHome AutomationnetAQUA Wi-Fi Web Enabled Irrigation Controller

netAQUA

9D QUICK START GUIDE Roslen Eco-Networking Products

netAQUA

9D Quick Start Guide

This document will guide you through the basic steps necessary to begin using the netAQUA 9D.

Package Contents

• netAQUA 9D

• 24VAC power brick, if you purchased the netAQUA with transformer

• Combination phillips and flat blade screwdriver

• Cable ties

• Ethernet cable

• Resource CD

• Quick Start Guide

Note: We recommend checking for the latest updates to software, the User Manual and other

documentation on the Roslen Eco-Networking Products website at http://roslen.com.

Overview of operation

Summary of content (4 pages)

PAGE 1
netAQUATM 9D QUICK START GUIDE Roslen Eco-Networking Products netAQUATM 9D Quick Start Guide This document will guide you through the basic steps necessary to begin using the netAQUA 9D.
PAGE 2
netAQUATM 9D QUICK START GUIDE Roslen Eco-Networking Products There are two user interfaces: • A web-browser based control and monitoring interface for accessing the unit from your computer, tablet or smartphone. • An integrated local control and monitoring interface on the netAQUA unit consisting of an LCD screen with 4 buttons and two LEDs along the bottom of the enclosure. The web-browser interface is a point-and-click interface that everyone is familiar with.
PAGE 3
netAQUATM 9D QUICK START GUIDE Roslen Eco-Networking Products 1. Prepare the power connection:. a. Connect the power cable to the 24VAC power brick. Note that there are 3 wires in the power cable, black, green and white. The 3 power brick terminals are labeled AC, GND, and AC. The green wire must connect to GND (Ground) on the power brick. It does not matter which of the two wires (black or white) of the power cable is connected to which AC terminal of the power supply. Or… b.
PAGE 4
netAQUATM 9D QUICK START GUIDE Roslen Eco-Networking Products 8. If you are connecting to your network via Ethernet, feed the Ethernet cable through the cable grommet on the bottom of the enclosure. 9. Feed the zone control wires through the cable grommet on the bottom right of the enclosure. Cut to length, strip and connect the colored wire from each watering zone pair to the appropriate Zone terminal. Connect the white common wires from each watering zone control cable to the Common terminals.