SERVER RSV-L4500 User Manual
SERVER RSV-L4500 User Manual Contents Product Overview ...............................................................................................................................................2 Introduction ................................................................................................................................................. 3 Feature.............................................................................................................................................
SERVER RSV-L4500 User Manual Product Overview 2
SERVER RSV-L4500 User Manual Introduction RSV-L4500 is a 4U rackmount industrial chassis for various kinds of server computer which supports any E-ATX (12” x 13”) and below form factor motherboard design and PS2 power supply. In addition, RSV-L4500 has a large-scale fan filter and easy-to-use knob key for great serviceability of the system. Feature Carries a total of 15x internal 3.5" HDDs.
SERVER RSV-L4500 User Manual 1x LED (power) +1 x LED (HDD), 2 x LED (LAN) 2x 2.0 USB Dimensions(L x W x H) 25" x 16.8" x 7.0" inches (635 x 427 x 178 mm) Weight Net Weight : 31.9 lbs. (14.5kg) Gross Weight : 39.8 lbs (18.
SERVER RSV-L4500 User Manual 3.5” Device Installation 1. First press the two round shape button using your thumbs, then use your index finger to push the 3.5” module to remove it. 2. The 5x HDDs module should look like this. Each Hard drive is mounted in the module using the HDD rail side by side. 3. You can see the Hard Drive installation guide in following section.
SERVER RSV-L4500 User Manual Hard Drive Rail Installation 1. Each Hard drive requires using 2x HDD rail on each side. 2. When alighting the HDD rail with Hard drive, please make sure that both pin on each rail will be insert into the hard drive’s screw holes. 3. The HDD rail should look like this when place correctly with Hard Drive. (Note: Please do not fasten screw on HDD Rail and Hard Drive at this stage, otherwise you will not be able to slide the HDD rail into the module) 4.
SERVER RSV-L4500 User Manual Server Rail Installation 1. In order to install the rail, you must first remove the cover on the side. Three screws locate on each side. 2. Unscrew all three screws on each side. 3. Upon removing the side bar, you will find several screw holes for you to install the server rail. Thank you for purchasing a quality Rosewill Product. Please register your product at: www.rosewill.com for complete warranty information and future support for your product.
