User manual

2.4.7 Settings
To access the Settings menu, highlight the Settings command from the toolbar, and press
Enter.
Select Boot Device – select which disk or array will act as the boot disk, if the
motherboard BIOS instructs the card to act as the boot device.
Staggered Drive Spinup – This option is disabled by default. Enabling this setting will
instruct the card to power up the hard disks, sequentially (one disk approximately every 2
seconds). Not all disk support this setting – consult the disk documentation for more
information.
Warning: Western Digital hard disks do not support this setting. Enabling this setting is
not recommended. If enabled, these disks may not be detected by non-RAID controllers.