User manual

Before creating a RAID array, the disks must be initialized. Disk initialization writes
necessary RAID configuration information to the hard disks. Select the Initialize
command from the toolbar, and press ENTER.
Highlight the target disks using the arrow keys, then select using Enter. A numeral will
be displayed before each selected disk. Once all target disks have been selected, press
ESC. The utility will display a warning, and ask you to press Y (yes) to initialize, or N
(no) to cancel. Once initialized, these disks can be used to create RAID arrays.
Warning: Initialization will destroy all pre- existing data on the selected hard disks.
Only initialize disks that do not contain critical data
Creating Arrays:
1. Select Create from the toolbar and press Enter.
2. Use the arrow keys to select the RAID level and press ENTER.