Installation guide

51
function of the connected camera. This option is available only
in single camera view mode.
If the connected camera features pan/tilt functions, you can
use this control panel to set the preset positions (up to 8
positions). Once configured, you can move the camera lens to
the desired position quickly.
To set the preset positions, adjust the camera lens to the
desired position using the Navigation buttons, and then select
the position number (1~8) from the Set button.
To move to the preset position, simply select the position
number (1~8) from the Go button.
Navigation Buttons (Left/Right/Up/Down/Home). If the
connected camera features pan/tilt functions, the Navigation
buttons allow you to move the camera lens position. Clicking
the Home (center) button will move the camera lens to the
assigned home position.
/
The Patrol/Stop buttons are used to enable/disable the
swinging function of the camera. Click Patrol to start patrolling
through the preset positions once. Click Stop to stop
patrolling.