Installation guide

32
- PBC Mode: The PBC (Push-Button-Configuration) mode builds the connection
by simply pressing a button on the device.
a. Click the PBC Mode option.
b. Click the Connect button to start WPS function of the camera.
TIP Instead of clicking the Connect button of Configuration Utility, you can press
the WPS button if the camera is designed with a hardware button of WPS
function.
c. You need to press the WPS button on the router (or access point) within
120 seconds to complete the setup.
 Device Status
Display the WPS configuration of the camera.
TIP The Power LED indicates the WPS connection status by:
- blinking 3 times when the connection is built successfully.
- repeating 3 times of short-short-long blink when the connection is failed.