Installation guide

17
3.3 Configuring the IP Address of the PC
If you are failed to access to the camera, please check the IP address of your computer.
When you connect the camera to your computer directly to proceed with configuration of
the camera, you need to set up the IP addresses to be in the same segment for the two
devices to communicate.
1. On your computer, click Start > Control Panel to open the Control Panel window.
2. Double-click Network Connection to open the Network Connection window.
3. Right-click Local Area Connection and then click Properties from the shortcut
menu.
4. When the Local Area Connection Properties window appears, select the General
tab.
5. Select Internet Protocol [TCP/IP] and then click Properties to bring up the
Internet Protocol [TCP/IP] Properties window.
6. To configure a fixed IP address that is within the segment of the camera, select the
Use the following IP address option. Then, enter an IP address into the empty
field. The suggested IP address is 192.168.0.x (x is 1~254 except 30), and the
suggested Subnet mask is 255.255.255.0.
7. When you are finished, click OK.