User's Manual

Item Description
IP Address Fill in the IP address of LAN interfaces of this WLAN AP Router.
Subnet Mask
Fill in the subnet mask of LAN interfaces of this WLAN AI Router.
Default Gateway
Fill in the default gateway for LAN interfaces out going data packets.
DHCP Server Click to select Disabled, Client or Server in different operation mode of
wireless AP router.
DHCP Client Range Fill in the start IP address and end IP address to allocate a range of IP
addresses; client with DHCP function set will be assigned an IP address
from the range.
Show Client Click to open the Active DHCP Client Table window that shows the
active clients with their assigned IP address, MAC address and time
expired information. [Server mode only]
802.Id Spanning Tree Select to enable or disable the IEEE 802.Id Spanning Tree function
from pull-down menu.
Clone MAC Address Fill in the MAC address that is the MAC address to be cloned. Refer to
4.24 What is Clone MAC Address?
Apply Changes Click the Apply Changes button to complete the new configuration
setting.
Reset Click the Reset button to abort change and recover the previous
configuration setting.
3.3.11 WAN Interface Setup
This page is used to configure the parameters for wide area network that connects to the WAN port of your WLAN AP
Router. Here you may change the access method to Static IP, DHCP, PPPoE or PPTP by click the item value of WAN
Access Type.
I Static IP
- 32 -
Screen snapshot - WAN Interface Setup - Static IP