User's Manual

2 Installation
2.1 Hardware Installation
Step 1: Place the WLAN AP Router to the optimum transmission location. The best
transmission location for your WLAN AP Router is usually at the geographic
center of your wireless network, with line of sign to all of your mobile stations.
Step 2: Connect the WLAN AP Router to your wired network. Connect the Ethernet
WAN interface of WLAN AP Router by category 5 Ethernet cable to your
switch/ hub/ xDSL modem or cable modem. A straight-through Ethernet cable
with appropriate cable length is needed.
Step 3: Supply DC power to the WLAN AP Router. Use only the AC power adapter
supplied with the WLAN AP Router; it may occur damage by using a different
type of power adapter.
The hardware installation is finished.
2.2 Software Installation
¾ There are no software drivers, patches or utilities installation needed, but only the
configuration setting. Please refer to chapter 3 for software configuration.
Notice:
It will take about 1 minute to complete the boot up
sequence after powered on the WLAN AP Router;
Power LED will be active, and after that the WLAN
Activity LED will be flashing to show the WLAN
interface is enabled and working now.
- 12 -