User's Manual
Table Of Contents
- 封面
- N900PCE_User Guide.pdf
- Package Contents
- Chapter 1 Introduction
- Chapter 2 Installation Guide
- Chapter 3 Configuration Guide
- Chapter 4 WPS Configuration
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
Fwcn"Dcpf"Yktgnguu"REK/G"Cfcrvgt"""""""""""""""""/"RNWD-N9003PCE/"""""""""""""""""""""""""""""""""Wugt‚u"Ocpwcn"
Ejcrvgt"6"YRU"Eqphkiwtcvkqp"
WPS (Wi-Fi Protected Setup) function allows you to add a new wireless device to
an existing network quickly.
If the wireless Router supports Wi-Fi Protected Setup (WPS), you can establish a
wireless connection between wireless card and Router using either Push Button
Configuration (PBC) method or PIN method.
"
Pqvg<"
WPS function is not supported in Windows 7 OS.
First, the WPS software should be installed. Insert the Resource CD into your
CD-ROM drive. To continue, double-click O{"Eqorwvgt, and then double-click
the EF1FXF drive where the installation CD was placed. Open P;22REG folder,
and double-click yru0gzg. Then you will see Figure 0-1.
Figure 0-1
Then, please follow the step-by-step instruction to complete the WPS installation.
After that, WPS function can be enabled. Here we will introduce two ways to
configure the WPS.
-35-