User's Manual
Table Of Contents
- 封面
- N900PCE_User Guide.pdf
- Package Contents
- Chapter 1 Introduction
- Chapter 2 Installation Guide
- Chapter 3 Configuration Guide
- Chapter 4 WPS Configuration
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
Fwcn"Dcpf"Yktgnguu"REK/G"Cfcrvgt"""""""""""""""""/"RNWD-N9003PCE/"""""""""""""""""""""""""""""""""Wugt‚u"Ocpwcn"
Figure 0-11
3. Highlight the profiles to add to auto profile selection, and click Cff. The profile will appear in
the Auto Selected Profiles box.
4. Highlight a profile in the Auto Selected Profiles box.
5. Click Oqxg"Wr or Oqxg"Fqyp as appropriate.
"
Pqvg<"
The first profile in the Auto Selected Profiles box has highest priority, while the last profile
has the lowest priority.
6. Click QM.
7. Check the Cwvq"Ugngev"Rtqhkngu checkbox on the Rtqhkng"Ocpcigogpv tab
(shown in Figure 0-2).
"
Pqvg<"
When auto profile selection is enabled by checking Cwvq" Ugngev" Rtqhkngu on the Rtqhkng"
Ocpcigogpv tab, the client adapter will scan for an available network. The profile with the
highest priority and the same SSID as one of the found networks will be used to connect to
the network. If the connection fails, the client adapter will try the next highest priority profile
that matches the SSID until an available network is found.
-28-